x
Layout R3
Mainsail:
Partial Batten with 2 reefs
Gaff - 92.5
inches, with 10 grommets;
Luff -
153.75 inches, with six grommets;
Foot - 135.5
inches, with 11 grommets;
Leech -
straight line measurement is 219.5 inches, there are 7 inches of
roach at the middle batten; and
Diagonal
- sail design
The first
reef is at 45.5 inches, measured from the edge of the sail
to the lower inside of the reef ring/cringle.
The second
reef is at 79.5 inches, measured the same way.
Three
battens, the lowest parallel to the Foot.
Press rings
at all corners -- 11/16 inside diameter
batten at 25% will be parallel to the foot.
The grommets on the luff should be 7/16 inch inside diameter
5/16 inside diameter on Gaff -- There should be 10 grommets
here
5/16 inch on the
foot
Tape reinforcement of the
luff leech and foot -- extra row of stitching
No Draft lines
Foresail:
Partial Batten - 2 reefs
Gaff - 76.5
inches, with 7 grommets;
Luff - 138
inches, with 7 grommets;
Foot - 84.25
inches, with 7 grommets;
Leech
- straight line
measurement is 188.5 inches, there are 6
inches of roach at the middle batten; and
Diagonal
- from Throat to Clew is 156 inches, (see note
above).
The first reef is at 29.5 inches, measured
from the edge of the sail to the lower inside of the reef
ring/cringle.
The second reef is at 59.5 inches,
measured the same way.
Three battens, the lowest parallel to the
Foot.
O Rings at all corners.
that the batten at 25% will be parallel to the foot.
The grommets on the luff should be 7/16 inch inside diameter
Gaff = 7 grommets , 5/16 inside diameter based on my
present sail.
5/16 inch on the foot
Press ring on Tackj head clew 11/16 inside diameter.
Tape
reinforcement of the luff leech and foot -- extra row of
stiching
No Draft lines
Layout R2
Jib:
Luff - 205.5 inches; (see below for details
on hanks)
Foot - 104 inches; and
Leech - 160.25 inches, with a leech line.
In the luff, there are 7 hanks. The bottom 3, measured
from the lower edge of the sail at the tack, are 15
inches, 57in inches and 98 inches from the tack -
these measurements are to the centre of the paired grommets
for the jackline. These pairs are 1.75 inches apart,
measured from centre to centre.. The jack line starts
at a small ring 102 inches from the tack.
Sail to have jack
line
Hanks to be seen on
dyneema Luff
Press ring on clew --- The ring on my present sail is 15/16 inside diameter
Sail needs to account for snag
No Draft lines
http://www.atkinboatplans.com/Articles/BDQ/FlorenceOakland/index.html